Displaying Tabular Polarization Rate Data in the CorrosionAnalyzer

From wiki.olisystems.com
Jump to: navigation, search

Polarization Rate Data Table

To display the polarization rate data in tabular you will need to customize the report. After the calculation has completed, click on the Report tab. Polarization Rate Table 2016 updated.jpg

Figure 1 The rates calculation has finished.

Reports Tab

You will see the default report for the rates of corrosion. The Polarization data is not included since the total amount of data is quite lengthy. To see this data, click on the Customize button. Reports Tab 2016.jpg

Figure 2 The default report for the rates of corrosion.

Report Contents

On the Report Contents tab, check the Polarization Curves box. This will place the tabular polarization curve data into the report.

Report Contents 2016.jpg

Figure 3 The default customize options. Polarization curves is unchecked.


Polarization Curves

In the Category window, select Polarization Curves. This will display a list of reactions in the window on the right. Select the curves you want by checking the appropriate boxes. By default, all boxes are checked.

Polarization Curves 2016.jpg

Figure 4 Selecting reactions


Select Reactions

check the reaction that you would like to keep, and deselect the reactions you would not like in the simulation.

Add or Remove Reactions 2016.jpg

Figure 5 Select only a few reactions


Final Results of Simulation

Click the OK button and you will be returned to the main report. Scroll down to find the polarization curve tabular data.

Final Report 2016.jpg

Figure 6 Scrolling down to find the tabular polarization curve data.

This was former Tip17.