Difference between revisions of "Login Error: Could not find a valid protection key with ID: PA..."

From wiki.olisystems.com
Jump to: navigation, search
(Created page with "Login Error: Could not find a valid protection key with ID: PA... This is a common error message when using the Sentinel HASP security solution. == Driver Failed to insta...")
 
(Failure to start softkey service)
Line 26: Line 26:
 
Please follow the instructions on the page <u>[[Installing the hardlock drivers manually]]</u>
 
Please follow the instructions on the page <u>[[Installing the hardlock drivers manually]]</u>
  
== Failure to start softkey service ==
 
  
Some systems are very stubborn to get running.  You may get an error message similar to the following:
 
 
[[File:E04.png]]
 
 
In that case please follow the instructions for [[Sentinel HASP Run-time installation - Error when starting the hasplms service with parameters...]]
 
 
When the drivers have been removed, please reinstall the drivers manually (see above)
 
  
 
[[Category: Error messages]][[Category: Softkey]][[Category: Drivers]]
 
[[Category: Error messages]][[Category: Softkey]][[Category: Drivers]]

Revision as of 13:43, 29 September 2017

Login Error: Could not find a valid protection key with ID: PA...

This is a common error message when using the Sentinel HASP security solution.


Driver Failed to install - Repair Drivers Button Method

Occasionally the drivers for the softkey will fail to install. There are a variety of reasons for this which are too numerous to list. If you are sure that the C2V/V2C process has been completed then the next step is to drivers.

On the warning dialog there is a min-tab called Protection Key tools please select that tab.

E01.png

On that tab there is a button that states Repair Drivers please click that button to see if the drivers are re-installed and then try the program again.

E02.png

Driver Failed to install - Manual Instillation Method

Sometimes the same issue that prevented the driver installation during the normal OLI product installation will also prevent the Repair Drivers button method from working. You may see an error similar to:

E03.png

In this case you will to download and install the drivers manually.

Please follow the instructions on the page Installing the hardlock drivers manually