Difference between revisions of "Diffusivity not available"

Latest revision as of 14:29, 8 October 2014

If you see an error like the following, there could be more than one reasons for it. The probable reasons are listed after the image.

@@ Line 1: / Line 1: @@
-Please note that the units for conditions used here could be different from the ones on the data you have. Another important factor to make a note of it unit conversions. If for example your pressure units are in Bar g, that roughly translates to adding 1.013 into the value you have to convert it into atmospheric units for pressure. Since g means gauge pressure, the numerical value for conversion to atm units could differ based on sea level of the location where original experiment is performed and/or data is collected. But for general purposes and feasibility of answers, it is safe to assume that adding 1.013 to Bar g value will yield Pressure in atm equivalent to the original value.
-If you see an error like the following, please know that the pressure is too low and the system is vaporizing to gaseous phase.
+If you see an error like the following, there could be more than one reasons for it. The probable reasons are listed after the image.
 [[File:Error message.png|500px]]
+* Pressure lower than dew point pressure
+* Temperature too high causing vaporization of the system
+* Not enough liquid phase present
+* Too much gaseous inflow resulting into stripping of the liquid phase
 [[Category:Error messages]]