Difference between revisions of "Total Dissolved Solids (TDS)"
Line 5: | Line 5: | ||
Both techniques heat a 1.0 L of solution of liquid to 180 <sup>o</sup>C which should remove all the volatile components. The mass remaining is the TDS in mg/L | Both techniques heat a 1.0 L of solution of liquid to 180 <sup>o</sup>C which should remove all the volatile components. The mass remaining is the TDS in mg/L | ||
+ | |||
+ | Occasionally this calculation will fail, especially with solutions that are dilute. In such cases an estimated TDS value is returned which is the sum of all liquid species minus water. | ||
[[category: Thermodynamics]] | [[category: Thermodynamics]] | ||
[[Category:Technical Challenges]] | [[Category:Technical Challenges]] |
Revision as of 09:27, 8 March 2019
How does OLI rigorously calculated TDS?
OLI originally developed the TDS calculation according to parameters set forth in ASTM D5907-03 (American Society of Testing Methods, West Conshocken, PA, United States). Recently this technique was modified to follow the parameters in ASTM D5907-18.
Both techniques heat a 1.0 L of solution of liquid to 180 oC which should remove all the volatile components. The mass remaining is the TDS in mg/L
Occasionally this calculation will fail, especially with solutions that are dilute. In such cases an estimated TDS value is returned which is the sum of all liquid species minus water.