Difference between revisions of "Displaying Tabular Polarization Rate Data in the CorrosionAnalyzer"
(3 intermediate revisions by the same user not shown) | |||
Line 44: | Line 44: | ||
'''Figure 6 Scrolling down to find the tabular polarization curve data.''' | '''Figure 6 Scrolling down to find the tabular polarization curve data.''' | ||
+ | This was former Tip17. | ||
− | [[Category:Tips]] | + | |
+ | [[Category:Tips]] [[Category:Corrosion]] [[Category:Former Tips]] [[Category: V9.2]] |
Latest revision as of 10:16, 11 July 2016
Contents
Polarization Rate Data Table
To display the polarization rate data in tabular you will need to customize the report. After the calculation has completed, click on the Report tab.
Figure 1 The rates calculation has finished.
Reports Tab
You will see the default report for the rates of corrosion. The Polarization data is not included since the total amount of data is quite lengthy. To see this data, click on the Customize button.
Figure 2 The default report for the rates of corrosion.
Report Contents
On the Report Contents tab, check the Polarization Curves box. This will place the tabular polarization curve data into the report.
Figure 3 The default customize options. Polarization curves is unchecked.
Polarization Curves
In the Category window, select Polarization Curves. This will display a list of reactions in the window on the right. Select the curves you want by checking the appropriate boxes. By default, all boxes are checked.
Figure 4 Selecting reactions
Select Reactions
check the reaction that you would like to keep, and deselect the reactions you would not like in the simulation.
Figure 5 Select only a few reactions
Final Results of Simulation
Click the OK button and you will be returned to the main report. Scroll down to find the polarization curve tabular data.
Figure 6 Scrolling down to find the tabular polarization curve data.
This was former Tip17.