Difference between revisions of "Displaying Tabular Polarization Rate Data in the CorrosionAnalyzer"
(→Report Contents) |
|||
| Line 16: | Line 16: | ||
== Report Contents == | == Report Contents == | ||
| + | On the '''Report Contents tab''', check the [['''Polarization Curves''']] box. This will place the tabular polarization curve data into the report. | ||
Revision as of 10:49, 7 July 2016
Polarization Rate Data Table
To display the polarization rate data in tabular you will need to customize the report. After the calculation has completed, click on the Report tab.
Figure 1 The rates calculation has finished.
Reports Tab
You will see the default report for the rates of corrosion. The Polarization data is not included since the total amount of data is quite lengthy. To see this data, click on the Customize button.
Figure 2 The default report for the rates of corrosion.
Report Contents
On the Report Contents tab, check the '''Polarization Curves''' box. This will place the tabular polarization curve data into the report.
